Difference between revisions of "Shifter"
m |
m |
||
| (2 intermediate revisions by the same user not shown) | |||
| Line 1: | Line 1: | ||
| − | + | {{X}} | |
| − | A '''gear stick''' (also '''gearstick''', '''gear lever''' and '''gear shifter''') is the lever used to change [[gear]] in a [[vehicle]], such as an [[automobile]], with [[manual transmission]] or [[automatic transmission]]. | + | |
| + | |||
| + | A '''gear stick''' (also '''gearstick''', '''gear lever''', '''selection lever''', '''shift stick''' and '''gear shifter''') is the lever used to change [[gear]] in a [[vehicle]], such as an [[automobile]], with [[manual transmission]] or several common forms of [[automatic transmission]]. | ||
[[Image:Manual Layout.PNG|thumbnail|Example shift pattern]] | [[Image:Manual Layout.PNG|thumbnail|Example shift pattern]] | ||
| + | [[Image:Shift stick.jpg|thumb|5 speed gear stick of a manual transmission car.]] | ||
| + | The device is used to change gear; in a manual transmission vehicle this will normally be done whilst depressing the [[clutch]] pedal with the left foot to disengage the [[engine]] from the [[drivetrain]] and [[wheel]]s. Automatic transmission vehicles, and those with [[continuously variable transmission]] gearboxes, do not require a clutch pedal. | ||
| + | |||
| + | ==Alternative positions== | ||
| + | Gear sticks are most commonly found between the front seats of the vehicle, either on the [[Center console (automobile)|centre console]] (sometimes even quite far up on the [[dashboard]]), the transmission tunnel, or directly on the floor. Some vehicles, especially older models, have a [[column shift]] where the lever is mounted to the [[steering column]]; typical examples include the [[Saab 96]], [[Citroen 2CV]] and [[Renault 4]]. The [[Bentley Mark VI]] had its gear lever to the right of the [[right-hand drive]] driver's seat, alongside the driver's door, where it was not unknown for [[United Kingdom|British]] cars to also have their [[Hand brake|handbrake]]. ([[Left-hand drive]] models received a column shift.) | ||
| + | |||
| + | In some modern [[sports car]]s, the gear lever has been replaced entirely by "paddles", which are a pair of levers, usually operating electrical switches (rather than a mechanical connection to the gearbox), mounted on either side of the steering column, where one increments the gears up, and the other down. | ||
| + | |||
| + | ==The gear knob and switches== | ||
| + | The ''gear knob'' (or ''shifter knob'') is at the end of the gear stick; it forms the handle of the gear stick. Typically the gear knob includes a diagram of the ''shift pattern'' of the gear selection system; ''i.e.'' the positions to which the gear stick should be moved when selecting a gear. In some older manual transmission vehicles it may incorporate a switch to engage an [[Overdrive (mechanics)|overdrive]]; in some automatic transmission vehicles it may incorporate a switch to engage a special mode such as a sports mode. Both of the above-mentioned switches may also be found on the console or on steering column stalks instead. | ||
| + | |||
| + | Many automatic transmission vehicles have extra controls on the gear stick, or very close by, which modify the choices made by the transmission system depending on engine and road speed; for example, "sports" or "economy" modes which will broadly speaking allow, respectively, for higher and lower revolutions per gear, before changing up. | ||
| + | |||
| + | Some specialist vehicles have controls for other functions on the gear stick. The [[Land Rover Freelander]] introduced a button for that company's [[Hill Descent Control system]] feature, which uses the brakes to simulate the function of a low-ratio gearbox in steep descents. | ||
| + | |||
| + | ==Secondary gear levers== | ||
| + | In some traditional [[four-wheel drive]] "off-road" vehicles there can be a second gear lever which engages a [[low-ratio gearbox]], used on tough [[terrain]]. Further, similar-looking levers may: switch between two- and four-wheel drive, or engage [[Differential (mechanical device)|differential]] locks; these are not "gear levers" however. | ||
| + | |||
| + | ==Shift pattern== | ||
| + | The "shift pattern" refers to the layout of the gears. In a typical manual transmission car, first gear is located forwards, and to the left. In many trucks and some sports cars it is instead in a "dog leg" position, back and to the left. There is usually a spring-loading to return the stick to the central position. Reverse gear is commonly positioned in the best choice of location to avoid accidental engagement. | ||
| + | |||
| + | A typical manual transmission vehicle, with (for example) five forward gears, will thus have seven possible positions: the five forwards gears, reverse gear, and a central "neutral" position. Some vehicles have a special button to prevent accidental engagement of reverse. Others require that the lever be lifted, pressed down, or moved with extra force to engage reverse. | ||
| + | |||
| + | Automatic transmissions traditionally have had a straight pattern beginning at the most forward position with "park" (which locks up the transmission), and running through reverse, neutral, drive (all gears available), and then the lower gears (often three or two more positions, each locking out a successive upper gear), with the rear-most position allowing first gear only. More modern automatic transmissions have employed a "J-gate" (pioneered by [[Jaguar (car)|Jaguar]]) where some gears are on the left-hand "arm", some on the right, and there is a sideways movement at the rear of the pattern. | ||
| + | |||
| + | Some modern gearboxes such as the [[Alfa Romeo]] [[Sportronic]] have a traditional automatic shift pattern to the right, with a special position to the left in which movement of the stick forwards and backwards increments the gears up and down respectively. | ||
| + | |||
| + | |||
| + | ==Issues== | ||
| + | A rare fault sees the gear stick and gear box in general completely shift, re-aligning where the gears are located. This places first gear where third usually is, and second, third and fourth where fourth, fifth and reverse normally are, respectively. This leaves no room for fifth gear or reverse, subsequently making the car unable to use these gears at all. The [[Mitsubishi Magna]] TR is most known for doing this.{{fact|date=November 2008}} | ||
| − | |||
== Trivia == | == Trivia == | ||
| Line 19: | Line 50: | ||
* [http://www.thefreedictionary.com/gearstick Free Online Dictionary entry] | * [http://www.thefreedictionary.com/gearstick Free Online Dictionary entry] | ||
| + | |||
| + | |||
| + | |||
| + | {{Automobile configurations}} | ||
[[Category:Auto parts]] | [[Category:Auto parts]] | ||
[[Category:Automotive transmission technologies]] | [[Category:Automotive transmission technologies]] | ||
Latest revision as of 08:27, 14 June 2009
A gear stick (also gearstick, gear lever, selection lever, shift stick and gear shifter) is the lever used to change gear in a vehicle, such as an automobile, with manual transmission or several common forms of automatic transmission.
The device is used to change gear; in a manual transmission vehicle this will normally be done whilst depressing the clutch pedal with the left foot to disengage the engine from the drivetrain and wheels. Automatic transmission vehicles, and those with continuously variable transmission gearboxes, do not require a clutch pedal.
Alternative positions
Gear sticks are most commonly found between the front seats of the vehicle, either on the centre console (sometimes even quite far up on the dashboard), the transmission tunnel, or directly on the floor. Some vehicles, especially older models, have a column shift where the lever is mounted to the steering column; typical examples include the Saab 96, Citroen 2CV and Renault 4. The Bentley Mark VI had its gear lever to the right of the right-hand drive driver's seat, alongside the driver's door, where it was not unknown for British cars to also have their handbrake. (Left-hand drive models received a column shift.)
In some modern sports cars, the gear lever has been replaced entirely by "paddles", which are a pair of levers, usually operating electrical switches (rather than a mechanical connection to the gearbox), mounted on either side of the steering column, where one increments the gears up, and the other down.
The gear knob and switches
The gear knob (or shifter knob) is at the end of the gear stick; it forms the handle of the gear stick. Typically the gear knob includes a diagram of the shift pattern of the gear selection system; i.e. the positions to which the gear stick should be moved when selecting a gear. In some older manual transmission vehicles it may incorporate a switch to engage an overdrive; in some automatic transmission vehicles it may incorporate a switch to engage a special mode such as a sports mode. Both of the above-mentioned switches may also be found on the console or on steering column stalks instead.
Many automatic transmission vehicles have extra controls on the gear stick, or very close by, which modify the choices made by the transmission system depending on engine and road speed; for example, "sports" or "economy" modes which will broadly speaking allow, respectively, for higher and lower revolutions per gear, before changing up.
Some specialist vehicles have controls for other functions on the gear stick. The Land Rover Freelander introduced a button for that company's Hill Descent Control system feature, which uses the brakes to simulate the function of a low-ratio gearbox in steep descents.
Secondary gear levers
In some traditional four-wheel drive "off-road" vehicles there can be a second gear lever which engages a low-ratio gearbox, used on tough terrain. Further, similar-looking levers may: switch between two- and four-wheel drive, or engage differential locks; these are not "gear levers" however.
Shift pattern
The "shift pattern" refers to the layout of the gears. In a typical manual transmission car, first gear is located forwards, and to the left. In many trucks and some sports cars it is instead in a "dog leg" position, back and to the left. There is usually a spring-loading to return the stick to the central position. Reverse gear is commonly positioned in the best choice of location to avoid accidental engagement.
A typical manual transmission vehicle, with (for example) five forward gears, will thus have seven possible positions: the five forwards gears, reverse gear, and a central "neutral" position. Some vehicles have a special button to prevent accidental engagement of reverse. Others require that the lever be lifted, pressed down, or moved with extra force to engage reverse.
Automatic transmissions traditionally have had a straight pattern beginning at the most forward position with "park" (which locks up the transmission), and running through reverse, neutral, drive (all gears available), and then the lower gears (often three or two more positions, each locking out a successive upper gear), with the rear-most position allowing first gear only. More modern automatic transmissions have employed a "J-gate" (pioneered by Jaguar) where some gears are on the left-hand "arm", some on the right, and there is a sideways movement at the rear of the pattern.
Some modern gearboxes such as the Alfa Romeo Sportronic have a traditional automatic shift pattern to the right, with a special position to the left in which movement of the stick forwards and backwards increments the gears up and down respectively.
Issues
A rare fault sees the gear stick and gear box in general completely shift, re-aligning where the gears are located. This places first gear where third usually is, and second, third and fourth where fourth, fifth and reverse normally are, respectively. This leaves no room for fifth gear or reverse, subsequently making the car unable to use these gears at all. The Mitsubishi Magna TR is most known for doing this.Template:Fact
Trivia
In the Goldfinger movie, James Bond's Aston Martin DB5 included an additional hidden button in the gear knob to activate the passenger seat as an ejector seat.
See also
External links